41
Figure 32. Geofence configuration
AutoGeofencing settings
AutoGeofence – the last known position after movement = off. If your car’s being
taken away – you can be notified. The shape and size of the geofence zones are
parameters. When object will leave geofence zone device will trigger an asynchronous
message
.
AutoGeofencing option can be configured by following parameters visible in Figure 38
below.
Activation TMO – Time period before Geofence is activated after vehicle stops.
Deactivate By:
Ignition – If ignition (configured Ignition Source) becomes high it will disable
AutoGeofenze Zone.
iButton – if iButton is attached it will disable AutoGeofence Zone.
Edit iButton List – if list is not empty, attached iButton is tested against an iButton list, if
match is found AutoGeofence zone is disabled.
Priority – Priority of generated event, which will be applied to saved record.
Exit Event – Event generation on Geofence exit.
On Both – Event generation on Geofence exit.
Note that AutoGeofencing does not require entering coordinates, instead it requires GNSS
visibility. If vehicle stopped and activation timeout has passed, an AutoGeofence will be created
around vehicle’s last position with set Radius value. AutoGeofence event generation works the
same as Geofencing mentioned above.
