122
Figure 65 Vehicle data configuration window
Element configuration (Figure ) shows selected element name (marked blue). By
selecting other element name will change that way indicating which element is configurating.
Priority: low and high. High, low level can be selected only by “Tachograph vehicle speed”, it
depends on generate event selection which have “On change” and “Monitoring” modes,
”Tachograph vehicle speed” has all (on exit, on enter, on both, hysteresis, monitoring, on
change) modes.
To reduce GPRS traffic we recommend using default settings (most I/O elements should be
generated “on change”)
Figure 66 Vehicle data configuration window
Below configuration available byte size in record is shown, by selecting elements its
decreasing and when reaches zero no more elements could not be selected.
Driver 1 ID and Driver 2 ID Tachograph data elements are packed to standard AVL packet
and send to server dependent on configuration with element ID described in „K LINE ID“ column.
Note that driver ID is 16 bytes long. For this reason it is split to 2 IO elements. On the server side
it is required to merge those two IO elements to have full driver ID for whole 16 bytes.
Summary of Contents for FM6320
Page 1: ...FM6320 User Manual V1 13...
