133
Figure 74
Terminal Window
To debug NMEA GPS data, connect PORT3 cable to COM2 port, or connect PORT2 cable and
enable nmea log mode, or via USB cable activating nmea log mode by sending
.log_nmea:1
command in terminal.
20
FM6320 REMOTE LOG
LOG BOOK
Two types of log book: online, offline.
Online log book is initiated using command
log2srv
and set right configuration. Device establish
GPRS
connection and activates link to server, log started to stream to server until set time is
elapsed. To stop streaming immediately
log2srvstop
is used.
Offline log book is initiated using command
log2srv
and set right configuration
.
Device start log
writing to flash, this action is performed until set time is elapsed.
To read offline log
log2srvstart
command is used. It sends log to earlier preconfigured server
(
log2srv
). Offline log sending also can be terminated using
log2srvstop
command.
COMMANDS
“SMSlogin<space>SMSpassword<space>
log2srv
<space><enable>,<mode>,<APN>,<userna
me>,<password>,<IP>,<port>,<TMO>,<Log mode>”
o
<enable> - enable (
1
), disable(
0
);
o
<mode> -
silent (
0
) – connect to server and send “Hello” message (all “Terminal”
commands can be used)
echo_time (
1
) – send log with lines, where is TIME “for example:
-
[2013.1.23 14:49:45]-[PERIODIC.BAN.LIST.INFO]:”
echo (
2
) – send log with lines where is no TIME “for example: [DIN1.FUNC]-
>Waiting for DIN1 to be ON”
echo/echo_time (
3
) – send full log
modem (
4
) – send just AT commands
NMEA (
5
) – send NMEA log.
Summary of Contents for FM6320
Page 1: ...FM6320 User Manual V1 13...
