Quick Manual v1.2 // FMM00A
15
Telematics
This message contains information on how to operate
FMM00A safely. By following these requirements and
recommendations, you will avoid dangerous situations. You
must read these instructions carefully and follow them strictly
before operating the device!
•
The device uses SELV limited power source. The nominal
voltage is +12 V DC. The allowed voltage range is +10…+30
V DC.
•
To avoid mechanical damage, it is advised to transport
the device in an impact-proof package. Before usage,
the device should be placed so that its LED indicators are
visible. They show the status of device operation.
•
Before unmounting the device from vehicle, ignition
MUST be OFF.
SAFETY INFORMATION
Do not disassemble the device. If the device is
damaged, the power supply cables are not isolated
or the isolation is damaged, DO NOT touch the
device before unplugging the power supply.
All wireless data transferring devices produce
interference that may affect other devices which are
placed nearby.
The programming must be performed using a PC
with autonomic power supply.
Please consult representatives of your vehicle
model regarding OBDII location on your vehicle.
In case you are not sure about proper connection,
please consult qualified personnel.
Installation and/or handling during a lightning storm
is prohibited.
The device is susceptible to water and humidity.
Teltonika is not responsible for any harm caused by
wrong cables used for connection between PC and
FMM00A
WARNING! Do not use FMM00A device if it distracts
driver or causes inconvenience due to OBDII
placement. Device must not interfere with driver.
Battery should not be disposed of with general
household waste. Bring damaged or worn-out
batteries to your local recycling center or dispose
them to battery recycle bin found in stores.
