Equipment required:
•
One battery charger for each PTC
•
An electrical outlet within 6 feet (1.8 meters) providing
110 volts AC in the U.S. or Canada or 220 volts AC
elsewhere
Note: If you are charging the PTC’s battery pack outside the
U.S. or Canada, you need a charger designed for use in a
220-volt AC electrical outlet.
The PTC-860 can be recharged either by itself or with a Telxon
microprinter attached. If you plan to recharge the PTC with
the microprinter attached, see the instructions provided with
the microprinter.
The PTC-860’s battery pack can also be recharged by the
optional CS-860 Optical Communication Station, MCO-860
Four-Bay Cradle, or PTC-860 Fast Battery Charger. If you plan
to use one of these accessories, see the recharging instructions
provided with that unit.
CAUTION! Do not charge a PTC-860NI’s battery pack in a
hazardous location. Accessories are approved for use with
the PTC-860NI only in non-hazardous locations.
1. Make sure the PTC is off.
2. Disconnect all accessories from the PTC.
3. Line up the 25-pin connector on the charger’s cable with
the connector on the PTC and push them together.
CAUTION! Do not force the connectors together if they do
not connect easily. You could bend the pins on the cable
connector.
If the connectors do not go together easily, check to make
sure they are lined up correctly, wide ends on the same
side, and no pins are bent on the cable connector.
20
