TEM A07A2200S Maintenance And Installation Manual Download

Page: 28 / 121

A07A2200S

CIRCUITS DESCRIPTION

5.1

AUDIO-IN board

The AUDIO-IN board has the task to interface the input audio signals with the modulator.
Level adjustments are performed on them, as well as pre-emphasis insertion and input
impedance selection. The outputs, going through a flat-cable to the mother board, are raised
to a high level and made balanced in order not to be interfered with the transformer flow
dispersion.

The LEFT and RIGHT signals available on the connectors placed on the rear panel enter,

after a first RF noise filter, respectively into U6 and U1. By the U11 switch and the Z1 jumper
accessible at the back, the input impedance can be selected (600

or 10k

). A similar function is

performed by the jumpers Z3, Z4, Z5, Z6, which allow to select the input nominal value level; on
the two channels MONO examined, the switches U13 and U12 change the gain by switching three
resistances or a trimmer to put the input level to 0, 4.1, 6, 12dBm or by RT3 and RT4 to a level
between

2 dB respect the nominal level if the jumpers 10a ( Fig. 9d page 60 ) are in the variable

position. The signal is then the pre-emphatized; the value 50µs or 75µs is chosen by the jumper Z2,
while the possible inserting is controlled by the front keyboard. Through U3 and U4 the LEFT and
RIGHT channels output is made differential.

The MULTIPLEX external signal path is simpler. On it, it’s only adjusted the level at the

nominal value by U16, still controlled by Z3, Z4, Z5, Z6. U9 adds up the MPX signal with the two
SCA signals and generates the balanced output signal.

Normally, on the SCA signals it’s difficult to establish an input nominal level since their

contribution to the frequency deviation is variable and depends both on the number of subcarriers
between 53 and 100KHz and on the difference about MONO or STEREO transmission. In any case,
the total deviation of all the subcarriers (19KHz, SCA1, SCA2) must not exceed 10% of the
maximum nominal deviation, which in most cases is ±75KHz. If the transmitter is monophonic and
only the RDS signal placed in one of the two SCA inputs is present, the deviation level of the
transmitted data can reach ±7,5KHz; whereas if the transmitter is stereophonic and besides the RDS
signal also a lower quality audio channel on a subcarrier is present, for example at 76KHz, the total
of each subcarrier deviations can’t exceed ±7,5KHz. The stereo driving carrier will deviate ±4KHz,
the RDS signal and the other audio channel will have to deviate, for example, ±1,75KHz.
For this reason, it has been preferred to make the SCA channel levels independent between the
nominal input one of the audio channels. The adjustment is obtained by RT1 and RT2 trimmers
always placed on the rear panel.

All the set levels are showed in the display and the choice to adopt a parameters manual setting
related to the input signals level has been preferred to an easier keyboard setting to avoid a non
standard levels setting which makes the servicing or the transmitter replacement problematical. The
audio signal level errors must not be cleared on the transmitter, but at a former stage. Normally,
every broadcasting station fixes a nominal level for all signals and all the adopted equipment must
respect this sole value. As higher is this value, as higher will be the noise immunity, and the signal
noise ratio as well.

380 221 R02

Pag. 28