Page 3
FRONT PANEL DISPLAY FUNCTIONS
KEYS & DISPLAY SYMBOLS
DIMENSIONS
TT33
PANEL CUTOUT
TT33
All dimensions in mm
1.
Press and release to set the time delays (if programmed with the parameter). Press for 5 seconds to enter the programming mode. Press
again to access the parameter edit mode and confirm the values. In programming mode press together with the key to change the programming level
of the parameters. When the keys are locked press the
and
keys together for 5 seconds to unlock the keys.
2.
When in programming mode, press to decrease the setting value and to select parameters.
3.
When in programming mode, press to increase the setting value and to select parameters. In programming mode press together with the
key
to change the programming level of the parameters. Press together with the
key to unlock the keys.
4.
Start/Stop:
Press for Start/Stop/Reset functions as programmed using the
parameter.
5.
SET LED:
In normal operating mode this indicates the time delays are being set. In programming mode this indicates the parameter programming level.
6.
CNT LED:
Indicates count in progress (flashes every 1 second), count interrrupted (steadily on) or the reset status (off).
7.
OUT2 LED:
Indicates the status of output relay 2 (illuminated for ON and not illuminated for OFF).
8.
OUT1 LED:
Indicates the status of output relay 1 (illuminated for ON and not illuminated for OFF).
mm
29 mm
