Tempco TEC-9100, Instructions Manual

4

1–4 Keys and Displays

KEYPAD OPERATION 

SCROLL KEY: 

This key is used to select a parameter to be viewed or adjusted. 

UP KEY: 

This key is used to increase the value of the selected parameter. 

DOWN KEY: 

This key is used to decrease the value of the selected parameter. 

RESET KEY: 

This key is used to: 

1. Revert the display to show the process value. 

2. Reset the latching alarm, once the alarm condition is removed. 

3. Stop the manual control mode, auto-tuning mode, and 

calibration mode. 

4. Clear the message of communication error and auto-tuning 

error. 

5. Restart the dwell timer when the dwell timer has timed out. 

6. Enter the manual control menu when in failure mode. 

ENTER KEY: 

Press 

 for 5 seconds or longer. 

 Press 

 for 5 seconds to: 

1. Enter setup menu. The display shows 

 . 

2. Enter manual control mode—when manual control mode 

 is selected. 

3. Enter auto-tuning mode—when auto-tuning mode 

 is 

selected. 

4. Perform calibration to a selected parameter during the 

calibration procedure. 

      Press 

 for 6.2 seconds to select manual control mode. 

      Press 

 for 7.4 seconds to select auto-tuning mode. 

      Press 

 for 8.6 seconds to select calibration mode.

R

TEMPCO

Table 1.1  Display Form of Characters

Display program code of the product for 
2.5 seconds. 
The left diagram shows program number 
6 for TEC-9100 with version 12. 
The program no. for TEC-7100 is 13, for 
TEC-8100 is 11 and for TEC-4100 is 12.