3) Press
UP/DOWN
key to choose the number of times you want the snooze alarm to repeat. Press
SET to confirm. You have now programmed the number of times the snooze alarm will go off as well
as how long you have to actually snooze between alarms
.
Alarm and Snooze Controls
:
4)
To turn on the alarm
functions, press
Mode
key once. Then press the
“UP”
button. You will see a
“
” appear above the time display. Press the “UP” button again and you will see a tiny “ZZ” below
the time display. At this point you have activated both the alarm and snooze functions.
5) To return to the normal display mode, press the
MODE
key twice or simply wait for 30 seconds.
6) When the alarm is active (going off), you may press any button to stop it. Pressing the SNZ button
will activate the previously programmed snooze times.
7)
To turn off the alarm,
press
MODE
once. Press
UP
button two times to turn off the alarm and the
snooze function. The “
“ & “ zz” will disappear.
The following functions allow you to set high and low alerts for indoor and outdoor temperatures
as well as high and low alerts for indoor humidity.
Temperature and Humidity Alert setting:
The following alert settings appear in this order: 1-Maximum outdoor Temp, 2-Minimum outdoor Temp,
3-Maximum indoor Humidity, 4-Minimum Indoor Humidity, 5-Maximum indoor Temp, 6-Minimum indoor
Temperature.
1) Press
MODE
key two times. Here’s what you should see.
2) Press and hold
SET
key for 3 seconds to enter the alert setting, the “90
℃
” (or “194
℉
”) will flash.
Outdoor temperature alert range is -50
℃
to 90
℃
(-58
℉
to 194
℉
)
3) Press down button to set the
HIGHEST OUTDOOR
temperature alert you need. Press
SET
button to confirm. The Minimum temperature will then flash (-50C). Press the up button to set
the
LOWEST OUTDOOR
temperature. Press
SET
to confirm. The unit will now go to the indoor
humidity alert setting.
4) Follow Step 3 above in setting the high and low
INDOOR HUMIDITY
levels and then the high
and low
INDOOR TEMPERATURE
levels.
5) Press and hold the “UP” button for two seconds to activate the alert system. “ “ will appear in
both the IN and OUT areas of the display. To de-activate the alerts, simply press and hold the
“DOWN” button.
6) When a temperature or humidity point has been exceeded, the TempMinder® will “Beep” for 5
seconds per minute until you press any button or the value being monitored returns to normal.
