6
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU BEGIN
TREADMILL
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE YOU BEGIN
TREADMILL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING & MAINTENANCE
LIMITED WARRANTY
After assembly, find your treadmill’s serial number and
model name located underneath the running deck.
ENTER YOUR SERIAL NUMBER AND
MODEL NAME IN THE BOXES BELOW:
SERIAL NUMBER:
MODEL NAME:
TOOLS INCLUDED
5 mm Allen Wrench
5 mm T-Wrench
Screwdriver
PARTS INCLUDED
1 Safety Key
1 Console Assembly
2 Roller End Caps
2 Hand Rails
2 Console Masts
4 Hardware Bags
1 Silicon Bottle
1 Water Bottle Holder
1 Deck Lock-Pin
If you have questions or if there are any missing parts, contact Customer Tech Support.
Contact information is located on the back panel of this manual.
For a complete exploded diagram, visit us at www.tempo-fitness.com
CONSOLE
READING RACK
WATER BOTTLE POCKET
CONTROL PANEL
SAFETY KEY PLACEMENT
CONSOLE MAST
MOTOR COVER
RUNNING BELT/RUNNING DECK
SIDE RAIL
REAR ROLLER
ADJUSTMENT BOLTS
ROLLER END CAP
ON/OFF SWITCH
CIRCUIT BREAKER
POWER CORD
DECK LOCK-PIN
TRANSPORT WHEEL
ASSEMBLY
During the assembly process of the treadmill there are several areas that special
attention must be paid. It is very important to follow the assembly instructions
correctly and to make sure all parts are firmly tightened. If the assembly
instructions are not followed correctly, the treadmill could have frame parts that
are not tightened and will seem loose and may cause irritating noises. There should
be no side-to-side play in the console masts or any forward and back play in the
console assembly or handlebars. If there is any play in these areas, the treadmill
has not been properly assembled. To prevent damage to the treadmill, the assembly
instructions must be reviewed and corrective actions should be taken.
IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE!
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place a protective covering on
your floor. Take
CAUTION
when handling and transporting this unit. Never open box when it is on its side. Once
the banding straps have been removed, do not lift or transport this unit unless it is fully assembled and in the
upright folded position, with the lock latch secure. Unpack the unit where it will be used. Never grab hold of any
portion of the incline frame and attempt to lift or move the treadmill.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NOTE:
Refer to the serial number and model name when calling for service.
NOTE:
Also enter this serial number on your Warranty Card.
621T DIAGRAM AND PARTS LIST
621T_Rev.1.7.indd 6-7
9/29/08 3:00:13 PM