COMPUTER OPERATIONS
11
2 USER PROGRAMS:
The user can also create his/her own programs to do workouts. There are two user
programs: U1 and U2
NO HEART RATE SIGNAL:
If the computer can not detect heart rate, the heart rate shows on computer will be
seconds.
The possible reasons for no heart rate signal:
1. Improper chest strap wearing
2. Not enough moisture on electrodes
3. The distance between chest strap and computer is over 1 meter
4. Need to change battery on chest strap transmitter.
STOP:
If the runner push "STOP" button during workout, the computer will be reset after 5 minutes
without push "START" button to resume workout.
CHEST STRAP TRANSMITTER and HAND PULSE:
1. The runner still can detect heart rate by gripping hand pulse after taking off chest strap
transmitter. (Use chest strap transmitter is much accurate to detect hear rate than use hand
pulse. Some runner is hard to detect heart rate by using hand pulse. We strongly suggest to
use chest strap transmitter if you need much accurate hear rate detection while using this
treadmill.)
2. Chest strap transmitter is priority than hand pulse if you wear chest strap transmitter and grip
hand pulse at same time.
3. The runner also can use chest strap transmitter to detect heart rate even do not use HRC
program.
0 after 15
U2 (user 2 program)
12 segments
speed range — 0.8~20kph
incline range — 0~15level
initial value at each segment:
speed:3.0kph
incline: level 5
1. Treadmill has been completely test at factory. The initial value would be different from the
monitor shows due to factory test.
2. Speed range 0.8~18kph would be different due to the treadmill specification.
U1 (user 1 program)
12 segments
speed range — 0.8~20kph
incline range — 0~15level
initial value at each segment:
speed: 3.0kph
incline: level 3
HAND PULSE
