OPERATION MENU’S
Boat Loader
When it is installed, this field shows the minimum and maximum
position of the boat. (The number of pulses per mm. is only
applicable to old step motors. The current servo motors do not use
this parameter).
External Pressure:
YES
: Nothing can be edited. Pressure will be controlled externally.
NO
:
The range may be edited (with a maximum of five sub ranges).
After editing the ranges, the PID can be entered.
To correct a mistake the cursor can be positioned over the incorrect value, using either the
<RETURN> key (to move down) or the <
> key (to move up). Enter the correct value
and confirm with the <RETURN> key. To move the cursor to the right or left, without
altering any digits, use
<
>
and
<
>.
Press <ESC> to return to the DPC Certification Menu.
6.2.1.3 Analog
Outputs
Figure 6-11 Analog Output
This screen displays the current settings of the analog outputs. To define an analog output,
select the number.
Give for each output the name (mnemonics, maximum eight characters), interlock type,
upstream or downstream valve, the minimum and maximum range value, the multiplication
factor and its unit. Confirm input data by pressing <RETURN>.
If there are more than four analog outputs, press <N> to go to the next four combinations.
T
OUCHSCREEN
R
EFERENCE MANUAL
6-11
