background image

 

 

 

Additional Information 

 

To avoid damaging your Tempod logger, please do not disconnect it from USB port while it is 

communicating with the computer. 

 

 

Data stored in Tempod logger is retrievable even battery runs out. 

 

 

Tempod logger uses CR2450 lithium battery, please do not heat, microwave or recharge it. Please 

contact your retailer for replacement. 

 

 

Please follow local regulations when recycling or disposing of Tempod logger. 

 

Warranty 

TempSen warrants this TempSen-branded hardware product against defects in materials and workmanship under normal use for a period 

of ONE (1) YEAR from the date of retail purchase by the original end-

user purchaser (“Warranty Period”). If a hardware defect arises and 

a valid claim within the Warranty Period, as its option and to the extent permitted by law, TempSen will either (1) repair the hardware 

defect at no charge, using new parts or parts equivalent to new in performance and reliability, (2) exchange the new product with a 

product is new or equivalent to new in performance and reliability and is at least functionally equivalent to the original product, or (3) 

refund the purchase price of this product. TempSen may request that you replace defective parts with new or refurbished user-installable 

parts that TempSen provides in fulfillment of its warranty obligation. A replacement product or parts, including a user-installable part that 

has been installed in accordance with instructions provided by TempSen, assumes the remaining warranty of the original product or 

ninety (90) days from the date of replacement or repair, whichever provides longer coverage for you. When a product or part is 

exchanged, any replacement item becomes your property and the replaced item becomes 

TempSen’s property. Parts provided by 

TempSen in fulfillment it’s warranty obligation must be used in products for which warranty service is claimed. When a refund is given, the 

product for which the refund is provided must be returned to Tem

pSen and becomes TempSen’s property. 

 

EXCLUSIONS AND LIMITATIONS 

This Limited Warranty applies only to the hardware product manufactured by or for TempSen that can be identified by the “TempSen” 

trademark, trade name, or logo affixed to it. The Limited Warranty does not apply to any non-TempSen hardware product or any software, 

even if packaged or sold with the TempSen hardware. Manufacturers, suppliers, publishers, other than TempSen, may provide their own 

warranties to the end user purchaser, but TempSen, 

in so far as permitted by law, provides their products “as is”. Software distributed by 

TempSen with or without the TempSen brand name (including, but not limited to system software) is not covered under this Limited 

Warranty. Refer to the licensing agreement accompanying the software for details of your rights with respect to its use. 

 

TempSen does not warrant that the operation of product will be uninterrupted or error-free. TempSen is not responsible for the damage 

arising from failure to follow instruc

tions relating to the product’s use. 

 

This warranty does not apply: (a) to consumable parts, such as batteries, unless damage has occurred due to a defect in materials or 

workmanship; (b) to cosmetic damage, including but not limited to scratches, dents, and broken plastic on ports; (c) to damage caused 

Summary of Contents for Tempod M1














Reviews: