The data logger is mainly used to record the temperature of food in storage and transportation.
It helps accurately monitor the whole process to indicate whether food is safe and fresh.
After the data logger is plugged into a computer USB port, a PDF data report will be
created automatically. The LCD screen will display report generation progress. When
created, the report can be viewed. The creation will not last for more than 4 minutes.
USB Port
LCD Screen
Configuration Info Label
Buttons
Sensor
Barcode Label
Users can reconfigure parameters via the data management software. The reconfiguration will clear the original parameters
and data
The logger supports three upper limits and two lower limits
The range that is out of alarm thresholds
The logger records the single time for continuous out-of-limit events
The data logger records the cumulative time of all the out-of-limit events.
The logger does not alarm immediately when the temperature is within the alarm zone. It begins to alarm
only when the alarm delay time elapses
Mean kinetic temperature is an evaluation method that indicates the effect of temperature fluctuation on
stored articles
single/cumulative
USB port
PDF format
single-use 3.6V lithium battery
IP65
Alarm type
Data interface
Report type
Battery
Battery life
Protection grade
internal NTC thermistor
Memory capacity
16000 readings (MAX)
Log interval
10 sec ~24 hr
Alarm threshold
default (customizable)
2 years (stored and used under normal
temperature environment)
Delayed start
Not started
Readings
Max temperature
Min temperature
Upper limit 3
Upper limit 2
Upper limit 1
Lower limit 1
Lower limit 2
Current time
Timing start
Start status
MKT value
Average temperature
12
13
14
15
16
PDF creation progress
Sensor fault
Alarmed
Mark
Data clear
USB communicating
Operating Instructions
Description of the menus
Description of the combined indicators and other status
Action
Operation
Start the data logger
Stop the data logger
Show status
Set Mark
Press and hold the start button for about 5 seconds
Press and hold the stop button for about 5 seconds
Press and release the start button
Press and hold the start button for about 5 seconds
Reusable-Use PDF Temperature Data Logger
TemLog MT1
