16
11. Adjusting TV set and receiver
There are two possibilities of interconnecting receiver and television set.
Follow the instructions of
one
of the two points only!
Either:
Connection with a TV coax cable (generally available in stores,
not comprised in the scope of delivery); sound reproduction will be only in
mono.
First, the receiving channel of the satellite receiver must be stored at the
TV set. (Refer to the operating instructions of your TV set regarding the
procedures for channel selection and storage.) The system must be
switched on (see menu option 12) in order to transfer a menu or a
television picture to the TV set. Now the receiving channel can be
searched at the TV set (see TV operating instructions). If a picture (menu
text or TV programme) appears on the TV, the correct channel has been
found. You should now store this channel at a program place of your
choice.
Or:
Connection via the TV Scart socket with a Scart cable (generally
available in stores, not comprised in the scope of delivery). Over this
connector a stereophonic sound play-back is possible.
You do not need to connect the provided TV coax cable in this case. You
need to do nothing further than to plug the Scart cable into the respective
TV Scart sockets of the devices. At the TV set, you need then only switch
to the programme designated “AV”.
Switch the system off again by pressing the key
on the operating
control device.
The external system returns now into its folded-down position.
The system is now ready for use.
You can find the most important functions for the operation on the
summary operating instructions on the next page.
Before switching on please make sure that you have an
unobstructed line of view toward the south because otherwise no
satellite reception is possible.