E-mail: tenamic@aliyun.com
05
PROGRAM PRIMARY FINGERPRINT
●
Hold the set button for 3 seconds when you hear beeps and the keypad flashes 3 times, the LEDs remain on
to indicate it is ready to accept a new fingerprint.
●
You will need swipe one finger across fingerprint scanner. You will need to swipe this finger three times. The
LED light will flash green once for each valid scan. After three time scans, the LED light will go out and the
fingerprint has been set successfully.
●
Note: Total 28 fingerprints can been program, the program method is same as the primary fingerprint.
PROGRAM PASSWORD
●
Hold the set button for 3 seconds when you hear beeps and the keypad flashes 3 times, the LEDs remain on
to indicate it is ready to accept a new user password. Then enter a user code 3-8 digits long then press the set
button again to confirm the user password, when you hear two beeps, the keypad LED light will go out,
indicating the password has been set successfully.
