Tendercare Ltd
The Snugseat Spring User Manual
Document No 034-01v4 Snugseat Spring
User Manual.doc
Authority.
Quality Controller
Authorised.
J Adams
Page 12
Dec 05
The senior size has two gas springs one either side of the seat.
The gas spring release lever, a chrome bar, is located under the
front of the seat. To operate place one hand on the middle front
of the seat just above the footrest location, and with the other
hand gently lift the gas spring release lever upwards
(see picture
opposite)
. Allow the seat to recline slowly, when the required
position is reached release the lever to lock the seat in position.
Important: - Always ensure the 5-point harness is used and correctly adjusted before
reclining or returning the seat to a more upright position.
Warning: - Always support the front of the seat when reclining, as the gas springs are very
quick in operation. If the front of the seat is not supported, the seat may
move swiftly and could cause the occupant distress
.
To return the seat to a more upright position, place one hand on the middle front of the seat,
just above the footrest location and use your body weight to push down. If extra leverage is
required place one hand on the footrest instead of the seat. At the same time use the other
hand to operate the gas spring release lever. When the required position is reached release the
lever.
5.0 Setting up the seat unit
When setting up the seat unit always ensure the following is done: -
Always consult your Therapist or Rehabilitation Engineer for advice.
Ensure that the child is relaxed and happy and if possible in an environment in which
they are familiar.
If possible, sit the child on a flat box of the correct height that has a conforming
surface.
Assess level of sitting ability.
Take the measurements listed below.
Measurement
Symbol
Millimetres
Inches
Pelvic Width
P.W.
Seat Depth
S.D.
Set Seat Depth
S.D. – 25mm (1”)
-25mm=
-1” =
Footrest Height
F.H.
