Tenergy 61336, Instruction Manual

15

Troubleshooting

Problem/Issue

Cause

Soluction

1

Cannot bind drone to 
controller

a) Battery
b) Electromagnetic interference
c) Out of range

a) Make sure the batteries in both drone and 
controller are fully charged
b) Clear out objects between drone and controller
c) Put drone and controller closer to each other

2 Drone does not turn on

a) Battery too low
b) Battery not fully plugged in

a) Charge battery
b) Battery fully plugged in the correct direction

3 Controller does not turn on

a) Switch didn't turn on
b) Battery didn't install correctly
c) Battery power too low

a) Ensure switch is turned on
b) Ensure battery fully plugged in correctly and 
securely
C) Charge the battery

4

Blades do not spin or 
drone has difficulty taking 
off the ground, LEDs are 
flashing

Battery power level is too low

Fully recharge the battery

5

Unstable drone flying / 
strong vibration

Damaged blade(s)

Replace the blade(s)

6

All blades spin but drone 
does not take off the 
ground or not flying 
properly

Blades are not installed correctly

Reinstall the blades following the "Blade 
Installation" section on page 13

7

Drone crashes 
immediately

Blades are not installed correctly

Reinstall the blades following the "Blade 
Installation" section on page 13

8

Drone crashes during 360° 
Roll

Not enough space to perform 
the rolling function

Ensure the drone is at least 9ft from ground and 
9ft away from all other objects in all direction

9

Drone can not perform 
360° Roll and LEDs are 
flashing

Battery power level is too low

Fully recharge the battery

10

Drone can not perform 

360° Roll but LEDs are

normal

Obstacle Avoidance Module

is installed

Remove the Obstacle Avoidance Module