www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
TM
TM
Page <12>
V1.0
23/08/18
IV. Replacement of heater
Please follow the following steps for the successful replacement of the heating element of hot-air rework station:
A. Cut down power, please refer to the following diagram to replace heater after it is cool.
B. Based on diagram, loosen the three screws of the handle.
C. Dismantle the upper cover of the handle, pull out the ground wire on the duct and take out the fan.
D. Take out the heating element from PCB board.
E. Insert new heating element in PCB board, pay attention to install properly.
F. Install it as the contrary method of remove.
Please follow the following steps for the successful replacement of heating element of soldering station:
A. Cut down power; replace the heating element after it is cool.
B. As following diagram, unscrew the nut 1, take out the stainless steel cap 2 and iron tip 3, then unscrew the fixed holder 4,
desoldering the heating element 5.
C. Replace the good condition heating element and install it as the contrary method of remove.
V. Soldering Tip Care and Use
a. Tip Temperature
• High soldering temperatures can degrade the tip
• Use the lowest possible soldering temperature. The excellent thermal recovery characteristics ensure efficient and effective
soldering even at low temperatures
• When not in use, do not leave the soldering iron on at a high temperature as the tip’s solder plating will get covered by oxide,
reduction it’s heat conductivity