www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
TM
TM
Page <6>
V1.0
23/08/18
Position Knob/Button
First function
Second function
(short press < 5s)
Second function
(long press > 5s)
Front
Panel
Buttons
SET
Set temperature and
confirmation varies
of settings
Press with knob and then se-
lect hot-air quick key 3 to set.
Press with knob and deposit
the setting of hot-air quick knob 3
Press with knob and then se-
lect hot-air quick key 3 to set.
Press with knob and deposit
the setting of iron quick knob 2
Work and shutdown
of soldering station
Group
Group
Hot-air
station
Front
Panel
Buttons
handle
knob
UP
To increase the Set value of hot-air station
DOWN
To decrease the Set value of hot-air station
Adjustment of air
volume
Blowing cold air of rework station
Awake hot air of rework station
Installation
The brackets for the handles must be installed when operating for the first time.
Please see the following illustration:
1. Please fix the bracket by tightening the four screws according to the illustration and your personal habit.
2. According to your selection, dismantle the two screws on the left or the right, which fix the bracket of the handle.
3. Place the two installation hole of the bracket to the two fixed screw holes of the machine, and then tighten the dismantled two
screws. Put the components of the handle on the bracket to check if it is suitable.
Introduction for LCD display
Description for LCD display
• Display “- - -” means the device is standby
• Screen “A” displays the working state of rework station.
• “P_ _” eans rework station is under the normal setting condition.