www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
TM
TM
Page <7>
V1.0
23/08/18
• “ P 0 1 “ means rework station is under the condition set by memory group 1.
• “ P 0 2 “ means rework station is under the condition set by memory group 2.
• “ P 0 3”means rework station is under the condition set by memory group 3.
• Both screen A and screen B display “ OFF” in the memory temperature area 2, which means the device, is standby.
• When the temperature area shines °C/°F the station is under the condition available to set.
Power
Upon power on the unit, the reworking station and soldering station be standby.
1. REWORK STATION
1. Power on:
Rework station start to work after press the “POWER” knob at the left of panel.
2.
At that time, if the handle is on the bracket, screen “ display state standby (diagram 3), or display the setting temperature
and 3 seconds later it display the actual temperature (diagram 4, diagram 5).
3. Temperature Settings
In normal condition, there are two methods to set temperature of hot-air reworking station.
A. If screen A shines °C/°F setting temperature through operating the button of panel. If screen A doesn’t shine °C/°F you must
press the “SET” button to switch to shine °C/°F of screen A then the station
Under the setting condition. Then you can press “SET” button to set hot -air rework station’s temperature and the main
temperature area shines the setting temperature, you can press UP knob or DOWN knob to adjust the setting temperature.
4s-no-press or press SET knob, you can keep the temperature and quit out this setting. (Diagram 6).
A. Setting temperature via handle of rework station. You can press UP knob or DOWN knob directly to adjust temperature and
the main temperature area indicators setting temperature. 4s-no-press or press SET knob, you can keep the temperature
and quit out this setting, at that time, you can adjust hot-air volume by pressing “ ” Whether screen A or screen B shine °C/°F
as you set, the device is under the setting condition and shining area for °C/°F switch to screen “A “ automatically.
Notice: continually pressing UP or DOWN knob in long time will quickly adjust the temperature, at that time, the screen don’t
shine. (Same as below description)