www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
TM
TM
Page <8>
V1.0
23/08/18
4. Hot-air volume settings
In normal working condition, there are two methods to set hot-air volume:
A. If screen A shines setting °C/°F temperature through operating the button of panel. If screen A doesn’t shine °C/°F you
must press the “SET” button to switch to shine °C/°F of screen A then the station under the setting condition. Then you can
press “SET” button to set hot-air rework station’ s temperature and the main temperature area shines the setting tempera-
ture, you can press UP knob or DOWN knob to adjust the setting temperature. 4s-no-press or press SET knob, you can
keep the temperature and quit out this setting (diagram 7).
B. Setting hot-air volume via handle of rework station. You can press UP knob or DOWN knob to adjust hot-air volume and
the main temperature area indicators setting volume. 4s-no-press or press SET knob, you can keep the volume and quit
out this setting, at that time, you can adjust hot-air volume by pressing “ ” When the screen A or screen B shine °C/°F as
you set, the device is under the setting condition and shining area for °C/°F switch to screen”A” automatically
5. Storing the Temperature values
Under normal working condition, hold down POWER knob at the left of panel, at the same time long press (>5s) the UP knob or
DOWN or SET to adjust temperature and air volume to the required values separately in term 1 or term 2 or term 3. But when
you hold down POWER knob at the left of panel and short press (<5s) UP or DOWN or SET knob to use the storage setting
temperature and air volume into current work temperature and air volume (diagram8, diagram9, diagram10).
(Notice: up, down, set refer to storage term 1, term 2, term 3)