www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
TM
TM
Page <6>
V1.0
03/01/19
User Manual
3.2 Front Panel
After powering on, the panel operation and all the functional buttons can be operated.
3.3 Voltage Setting
The voltage setting range is from 0.30V to 30V; follow the setting steps as below:
1. Switch on the power supply
2. Push the
OUT
button to stop power output
3. Push the
SET/ENTER
button, the max value flashes in the voltage setting area
4. Push the
LEFT
or
RIGHT
arrow keys to move the cursors
5. Push the
UP
or
DOWN
arrow keys to change the settings
6. Push
SET/ENTER
button to exit voltage setting mode
UP
ENTER
OUT SET
0 0.0 0
V ------------- >
3 0.0 0
V ---------------> OK.
Remark:
I. It is possible to set voltage values once the outputs are valid. However, for protection of the load, it is recommended to turn
off the output before setting the voltage.
II. Due to the total power limit, current settings will be decreased automatically as voltage setting increases.
3.4 Current Setting
The current setting range is from 0.000A to 3.750A, follow the setting steps as below:
1. Switch on the power supply
2. Push the
OUT
button to stop the output
3. Push and
SET/ENTER
button, the max value position flashes of voltage setting area.
4. Push the
V/A
button, the max. value position of current setting flashes and current setting is activated
5. Push the
LEFT
or
RIGHT
arrow keys to move the cursors
6. Push the
UP
or
DOWN
arrow keys to change the settings
7. Push
SET/ENTER
button and light off this button to exit current setting mode
UP
ENTER
OUT SET
V/A
0. 000
A ------------- >
2.000 A
---------------> OK.
Remark:
I. It is possible to set current values once the outputs are valid. However, for protection of the load, it is recommended to stop
output before current setting.
3.5 Output Switch
Under the panel operating mode, push OUT button to shift output status. Once OUT button is on and lit up, the measured
values displayed at LCD; push OUT button again to exit output mode.
3.6 Data Saving Operation
1. Under the voltage setting or current setting mode, push the
STORE
button to save the values of voltage or current into the
memory of power supply for future recall purpose.
2. Refer 3.3 or 3.4 for voltage or current setting mode.
3. Push
STORE
button to enter data saving mode, the minimum value position flashes and displays STORE icon on LCD.
4. Move
UP
or
DOWN
arrow keys to select storage group number.
5. Click
ENTER
button to confirm data saving, click
STORE
button to exit data saving mode.
UP
SET STORE
1
2
ENTER
-----> OK.
