www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
www.mcmelectronics.com
TM
TM
Page <1>
V1.0
16/05/13
User Manual
Desoldering Station
Part Number : SS-331BC-F
1. Description
SS-331BC-F designed for lead free desoldering especially. The quick heating and strong power are for convenient
and clear soldering / desoldering all types of DIP components.
Reasonable structure, single hand operation and strong absorbing power can be easy removal of the residual solder
from the one-sided or two sided of the PCB. This tool is used in the fields of electronic research, teaching and
production, especially in the repairing and desoldering on the electronic appliances and communication equipment.
1.1 Control
Unit
The desoldering iron gun is controlled automatically by the micro-processor. The digital control electronics and
high-quality sensor and heat exchange system guarantee precise temperature control at the soldering tip. The
highest degree of temperature precision and optimal dynamic thermal behavior under load conditions is obtained by
the quick and accurate recording of the measured values in a closed control circuit, and this design is especially for
the lead-free production technics.
1.2 Desoldering Iron gun
Desoldering iron gun with a power of 60W (Heat up rating 130W) and a wide spectrum of soldering tips can be
used anywhere in the electronics field. The high power and gun type design make this iron gun suitable for fine
desoldering work. The heating element is made of PTC and the sensor on the desoldering tip can control the
desoldering temperature quickly and accurately.
2.
Technical Specification
Rated voltage range AC220-240V; rated power input 140W; 50Hz.
3.
Operating Instruction
Caution : Make sure that the four screws which are used to fasten the Diaphragm pump are removed from the
control system before use. Otherwise serious damages may be caused to the user and the system.
3.1
Place the desoldering iron gun in the holder separately. Then connect the plug to the receptacle on the
station and turn clockwise to tighten the plug nut. Check that the power supply is corresponding to the specification
on the type plate and the power switch is on the “OFF” position. Connect the control unit to the power supply and
switch on the power. Then a self-test is carried out in which all display elements are switched on briefly. The
electronic system then switches on automatically to the set temperature and displays this value
3.2
The display and temperature setting.
