www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
www.mcmelectronics.com
TM
TM
Page <2>
V1.0
16/05/13
User Manual
Desoldering Station
3.2.1 Shows the actual temperature of the desoldering tip.
3.2.2 Shows the setting temperature: Pressing the “UP” or “DOWN” button can switch the digital display to
the set point display. The set-point can be changed for ±1°C by tapping the “UP” or “DOWN” button.
Pressing the button will change the set-point quickly. The digital display will return automatically to the
actual value and the iron will reach to the setting temperature quickly.
3.2.3 °C/°F display: Switching the temperature display from °C to °F by pressing the “°C/°F”button and
then the electronic system will display the actual temperature (1) and setting temperature (2) in °F,
and vice versa.
3.2.4 When the actual temperature on the soldering tip is less than the set-point, “HEAT ON” will display and
make the desoldering tip heating up.
3.2.5 When the absolute offset is more than ±10°C between the actual temperature and the set-point on the
soldering tip or the nozzle, “WAIT” will display. It means that the temperature electronic control system
is not in the stable situation, we should wait a moment to let the “WAIT” disappear.
3.2.6 When “ERROR” display, there may be a trouble on the system, or the soldering iron is not connected to
the control system correctly.
4.
Safety Instruction
4.1
The manufacturer assumes no liability for uses other than those described in the operating instructions or
for unauthorized alterations.
4.2
The operating instructions and cautions should be read carefully and kept in an easily visible location in the
vicinity of the control system. Non-observance of the cautions will result in accidents, injury or risks to health.
5. Caution
5.1
The power cord only can be inserted in approved power sockets or adapters.
5.2 High
Temperature
The temperature of the soldering tip will reach as high as around 400°C (752°F) when the power switch is on. Since
mishandling may lead to burns and fire, be sure to comply with the following precautions:
5.2.1 Do not touch metallic parts near the soldering tip/ nozzle.
5.2.2 Do not use this system near the flammable items.
5.2.3 Advise other people in the work area that the unit can reach a very high temperature and should be
considered potentially dangerous.
5.2.4 Turn off the power switch while taking breaks and when finishing using.
5.2.5 Before replacing parts or storing the system, turn off the power and let it cool down to the
room temperature.
5.2.6 Warning: this tool must be placed on its stand when not in use.
5.2.7 A fire may result if the appliance is not used with care, therefore:
5.2.7.1 Be careful when using the appliance in places where there is combustible material.
5.2.7.2 Do not apply to the same place for a long time.
5.2.7.3 Do not use in presence of an explosive atmosphere.
5.2.7.4 Be aware heat may be conducted to combustible materials that out of sight.
5.2.7.5 Place the appliance on its stand after use and allow it to cool down before storage.
5.2.7.6 Do not leave the appliance unattended when it is switched on.
