www.element14.com
www.farnell.com
www.newark.com
www.cpc.co.uk
www.mcmelectronics.com
TM
TM
Page <11>
V1.0
12/04/13
Rework Station
Instruction Manual
Operating Guidelines:
3. Wait for a few seconds while the device is adjusting the actual temperature. The control panel will then display ‘AXXX’ to
indicate the actual temperature. Note that actual temperature may vary for ±5% of the defined value. This is normal and should
not have any negative impact on reworking.
Note:
The temperature range is between 60°C and 480°C.
Airflow Level Setting and Adjustment
1. While the unit is ON and the Hot Air Gun switch set to “Reworking”, press buttons C3 or C4 from the control panel to increase
or decrease the airflow level, respectively.
2. The display panel, B2, will show something like ‘EYYY’ while air pressure is being adjusted.
3. Wait for a few seconds until the panel displays ‘FYYY’ indicating that actual airflow level has been reached.
Note:
The airflow level range is between 6 and 99.
