TM-901
Changing Default Category
and Types(UTP/FTP) Options
User must selects corrects type and category to
acquire accuracy measures length.
Press
key to turn on verifier. ( If the tester is
already on, skip this)
In the display wiremap, press the
key into
setting mode.
Press
and
key to select number zero from
No.0~9 . Press
key into setting cable category
and type. As shown in Figure.
Press
and
Key to select cat5 or cat6, and
Press
key to enter.
Press
and
key to select UTP or FTP, and
Press
key to enter and finish setting.
EN-18
Summary of Contents for TM-901
