OPERATION
2Ć7
1186 MM267 (6–94)
CLUTCH HANDLES
The clutch handles control the wheel drive clutch.
To move the machine forward, pull the clutch
handle until the desired speed is reached. To stop
the machine, release the handle.
To move the machine backward, press the clutch
reverse handle. To stop the machine, release the
handle.
SOLUTION FLOW SWITCH
The solution flow switch
controls the solution
flow to the floor. To start solution flow to the floor,
flip the switch toggle up. To stop the solution flow
to the floor, flip the switch toggle down.
FILTER SHAKER BY-PASS SWITCH
The filter shaker by-pass switch
controls the
automatic filter shaker. When the switch is in the
“on” position, the filter shaker motor will shake the
dust from the filter for 20 seconds when the
machine is turned off. When the switch is in the
“off” position, the filter shaker motor will not shake
the dust from the filter when the machine is turned
off. The switch should be in the “off” position when
servicing the machine or when scrubbing.
AMMETER
The ammeter registers the charging current which
is being passed to the battery by the alternator. It
also registers a discharge of current being used
by the machine when the alternator is not
charging.
MAIN BRUSH LEVER
The main brush lever controls the position of the
main brush. To raise the main brush, pull the lever
up, to the right and back into the
(Main
Brush Up) position (lower groove). To lower the
main brush on smooth surfaces, push the lever
forward and pull it back into the
(Main Brush
Down) position (top groove). To lower the main
brush on uneven surfaces, push the lever forward,
to the left, and release it into the
(Main
Brush Free-Float) position.
When parking the machine, always raise the
brush to prevent the bristles from taking a set.
To increase main brush contact with the floor, turn
the main brush lever to the left. To decrease main
brush contact with the floor, turn the lever to the
right.
C
D
E
B
A
03134
MAIN BRUSH LEVER
A. Main Brush Lever
B. Instrument Panel
C. (Main Brush Up) Position
D. (Main Brush Down) Position
E. (Main Brush Free-Float) Position
HOUR METER
The hour meter records the number of hours the
machine has operated. This information is useful
in determining when to service the machine.
START SWITCH
The start switch
controls the engine starter
motor. To start the engine, turn the on-off switch
to the right and push the start switch.
NOTE: Do not engage the starter for more than
ten seconds at a time, or after the engine has
started, as the starter may be damaged.
KEY-OPERATED ON-OFF SWITCH
The key-operated on-off switch
has two
positions: off and on. To start the engine, turn the
key fully to the right to the on position. To stop the
engine, turn the key to the left to the off position.
Summary of Contents for 1186
