OPERATION
2Ć13
1186 MM267 (6–94)
TO SCRUB
Plan the scrubbing in advance. Try to arrange
long runs with minimum stopping and starting. Do
an entire floor or section at one time.
Pick up oversize debris before scrubbing.
Remove bulky debris from aisles before
scrubbing. Pick up pieces of wire, twine, string,
etc., which could become entangled in brush or
brush plugs.
Allow a few inches overlap of brush paths.
Try to scrub as straight a path as possible. Avoid
bumping into posts or scraping the sides of the
machine.
Floor conditions, amount of soilage, type of
soilage, brush action, and squeegee action all
play an important role in determining the type and
concentration of detergent to be used. For
specific recommendations, consult the local
TENNANT Representative.
WARNING: Flammable Materials Can
Cause An Explosion Or Fire. Do Not
Use Flammable Materials In Tank(s).
The solution tank should be drained whenever the
float rises and stops water vacuum, or when done
scrubbing.
For best scrubbing results, reduce speed to
one-half maximum machine speed. Shut off
solution flow to floor 5 ft (1.5 m) before making
turns. Always raise the rear squeegee before
backing machine.
1. Stop the engine before filling the solution
tank.
FOR SAFETY: Before Leaving Or Servicing
Machine; Stop On Level Surface, Set Parking
Brake, And Turn Off Machine.
NOTE: The filter shaker by-pass switch should be
in the “off” position to prevent the filter shaker
from shaking.
2. Open the solution tank cover.
C
B
A
06315
SOLUTION TANK COVER
A. Solution Tank
B. Cover
C. Soap Basket
3. Pour the required amount of detergent into
the soap basket. Fill the tank with water to
4 in (100 mm) below the tank opening.
NOTE: The water must not be hotter than 130
F
(54
C) or tank damage may occur.
4. Start and drive the machine to the area to
be scrubbed.
5. Move the main brush lever into the (Main
Brush Down) or (Main Brush Free-Float)
position.
6. Move the side brush arm into the down
position.
7. Pull out the vacuum shut-off knob.
8. Turn on the solution flow switch.
9. Lower the squeegee lever into the down
position.
10. Scrub as required. When done scrubbing,
return to the solution dump/filling site. Drain
the solution tank, empty the debris hopper,
and refill the solution tank.
WARNING: Flammable Materials Or
Reactive Metals Can Cause Explosion
Or Fire. Do Not Pick Up.
Summary of Contents for 1186
