OPERATION
12
Tennant 2260/2270 (10–02)
MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
OPERATING MACHINE
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an
area where flammable vapors/liquids or
combustible dusts are present.
1.
Plug the power cord into a grounded wall outlet
(Figure 8).
Grounded
3 Hole Outlet
Ground Pin
FIG. 8
FOR SAFETY: Do not operate machine unless
cord is properly grounded. Do not operate
machine with damaged cord or plug. Do not
operate machine with the use of an extension
cord.
2.
Position the dual speed selector switch downward
(slow) for scrubbing/stripping and upward (fast) for
spray buffing (Figure 9).
FIG. 9
3.
Lower the handle to a desired operating height by
pulling the handle height adjustment lever.
Release lever to engage handle (Figure 10).
FIG. 10
4.
Before starting the machine, hold the handle so
the machine base is parallel to floor (Figure 11).
This will reduce the abrupt jolt when starting the
machine.
FIG. 11
NOTE: For first time users, practice with a polishing
pad which is less aggressive.
5.
To begin scrubbing, hold the handles firmly,
depress the safety lock levers and pull the On/Off
levers. Release safety lock lever once machine
starts (Figure 12).
ATTENTION: Use caution when starting out, the
machine will jolt when the On/Off levels are
activated.