OPERATION
6
Tennant 2360 (09–01)
SAFETY PRECAUTIONS
This machine is intended for commercial use. It is
designed to scrub hard floors in an indoor environment
and is not constructed for any other use. Use only
recommended pads, brushes and cleaning solutions.
The following safety alert symbols are used throughout
this manual as indicated in their description.
WARNING: To warn of hazards or unsafe
practices which could result in severe personal
injury or death.
FOR SAFETY: To identify actions which must be
followed for safe operation of equipment.
The following information signals potentially dangerous
conditions to the operator or equipment:
FOR SAFETY:
1.
Do not operate machine:
–
Unless trained and authorized.
–
Unless operator manual is read and
understood.
–
In flammable or explosive areas.
–
Unless cord is properly grounded.
–
With damaged cord or plug.
–
If not in proper operating condition.
–
In outdoor areas.
–
In standing water.
–
With the use of an extension cord.
2.
Before operating machine:
–
Make sure all safety devices are in place
and operate properly.
3.
When using machine:
–
Do not run machine over cord.
–
Do not pull machine by plug or cord.
–
Do not pull cord around sharp edges or
corners.
–
Do not unplug by pulling on cord.
–
Do not stretch cord.
–
Do not handle plug with wet hands.
–
Keep cord away from heated surfaces.
–
Do not release handle grips until pad
comes to a complete stop.
–
Go slow on inclines and slippery surfaces.
–
Report machine damage or faulty
operation immediately.
4.
Before leaving or servicing machine:
–
Turn off machine.
–
Unplug cord from wall outlet.
5.
When servicing machine:
–
Unplug cord from wall outlet.
–
Avoid moving parts. Do not wear loose
jackets, shirts, or sleeves.
–
Use manufacturer supplied or approved
replacement parts.
WARNING: Hazardous Voltage. Shock or
electrocution can result. Unplug machine before
servicing.
WARNING: Flammable materials can cause
an explosion or fire. Do not use.
GROUNDING INSTRUCTIONS
Machine must be grounded. If it should
malfunction or breakdown, grounding provides a
path of least resistance for electrical current to
reduce the risk of electrical shock. This machine
is equipped with a cord having an
equipment–grounding conductor and grounding
plug. The plug must be plugged into an
appropriate outlet that is properly installed in
accordance with all local codes and ordinances.
Do not remove ground pin; if missing, replace
plug before use.
Grounded Outlet
Grounding
Edge/hole
Grounded
3 Hole Outlet
Ground Pin
(120V)
(230V/240V)
Home
Find... Go To..
