![background image](http://html1.mh-extra.com/html/tennant/242e/242e_operators-manual_1087006051.webp)
MAINTENANCE
3-11
242E MM243 (5---92)
2. Unthread and discard the hydraulic fluid filter
element.
An older style hydraulic filter contained a filter
cartridge. Remove the outer case and discard
the cartridge.
NOTE: Be aware the hydraulic filter is below the top
of the hydraulic fluid reservoir. Some hydraulic fluid
will drain from the reservoir. Discard all hydraulic fluid
drained from the system. Drained hydraulic fluid may
contain foreign material harmful to the hydraulic
system.
3. Apply a thin coat of hydraulic fluid to the seal of
the new hydraulic fluid filter element.
4. Thread and hand tighten the new hydraulic
fluid filter element on the filter head.
A
B
05538
HYDRAULIC FLUID FILTER
A. Element
B. Filter Head
5. Operate the machine and check for leaks.
Correct any leaks found.
6. Check the hydraulic fluid reservoir level and fill
as required.
HYDRAULIC PUMPS
The machine propelling pump is a variable
displacement hydraulic piston pump. It is driven by
the electric motor via a v-belt.
The machine accessories pump is a hydraulic gear
pump. It is tandem mounted to the hydraulic piston
pump.
After repairing or replacing a hydraulic pump, or
when system contamination is likely, change the
hydraulic fluid in the reservoir and the hydraulic fluid
filter. Then the proper start and break-in procedure
must be followed to prevent possible damage to the
pump.
TO START AND BREAK-IN HYDRAULIC PUMP
outlines the procedure.
TO START AND BREAK-IN HYDRAULIC PUMP
1. Turn off the machine, set the machine parking
brake, and block the front tire of the machine.
FOR SAFETY: Before Leaving Or Servicing
Machine; Stop On Level Surface, Set Parking
Brake, And Turn Off Machine And Remove Key.
FOR SAFETY: When Servicing Machine, Block
Machine Tires Before Jacking Machine Up.
2. Jack up the rear of the machine at the
designated locations.
FOR SAFETY: When Servicing Machine, Jack
Machine Up At Designated Locations Only. Block
Machine Up With Jack Stands.
3. Block up the machine with jack stands near the
designated locations. Make sure the rear tire
clears the floor by 2 in (50 mm) and the floor is
cleared of all obstacles within a 24 in (610 mm)
radius.
4. Fill the hydraulic fluid reservoir with 5 gal
(19 L) of new, approved hydraulic fluid.
5. Fill the hydraulic pump through the case drain
port with hydraulic fluid.
6. Start the machine.
7. Press the directional control pedal one-half of
its travel in the “forward” direction while also
operating the hydraulics for one minute.
Summary of Contents for 242E
