![background image](http://html1.mh-extra.com/html/tennant/242e/242e_operators-manual_1087006073.webp)
MAINTENANCE
3-33
242E MM243 (5---92)
The side brush pattern adjustment on multi-level
dump model machines is made by loosening the two
screws on the side brush arm, repositioning the side
brush assembly, and retightening the screws.
A
B
C
00603
MULTI-LEVEL DUMP MODEL SIDE BRUSH
A. Screw
B. Side Brush Arm
C. Side Brush
TO REPLACE SIDE BRUSH
1. Empty the debris hopper.
2. Raise the hopper, engage the hopper support
bar, and lower the hopper onto the support bar.
WARNING: Raised Hopper May Fall.
Engage Hopper Support Bar.
3. Turn off the machine and set the machine
parking brake.
FOR SAFETY: Before Leaving Or Servicing
Machine; Stop On Level Surface, Set Parking
Brake, And Turn Off Machine And Remove Key.
4. Raise the side brush.
5. Remove the screw and nut holding the side
brush hub on the side brush drive shaft.
A
B
02485
SIDE BRUSH
A. Side Brush
B. Retaining Pin
6. Slide the side brush off the side brush drive
shaft.
7. Slide the new side brush onto the side brush
drive shaft.
8. Insert the screw through the side brush hub
and shaft and tighten the nut.
9. Disengage the hopper support bar and lower
the hopper.
Summary of Contents for 242E
