EN
ENGLISH
8
BR2020/T (04–98)
Meter Needle
GREEN
ZONE
RED
ZONE
Pad Pressure Meter
CAUTION: Never operate in Red zone,
floor damage and brush motor overload may
result.
NOTE: If machine vibrates, realign pad.
CAUTION: Keep machine moving at all
times to prevent floor damage.
6.
To stop machine, release control grips.
7.
To operate machine in reverse, release grips
and pull reverse trigger (one speed).
Reverse Trigger
8.
To transport machine, turn off pad switch and
twist control grips. Pad will automatically raise
to the transport position.
Turn Off Pad Switch
CAUTION: When transporting machine
without burnishing, tilt machine back to
protect dust skirt.
WHILE OPERATING MACHINE
WARNING: Keep hands and feet clear of
revolving pad.
1.
Tilt machine back when operating over
thresholds and other floor obstructions to
protect dust skirt.
2.
Always operate with caution when burnishing
around walls and obstacles.
3.
Always reduce speed to maintain control
when turning.
4.
Stay clear of floor obstructions, such as
electrical plates or grates, they will destroy
pad.
5.
Change or turn pads over when soiled.
6.
Check battery meter’s discharge level
periodically. Recharge when needle drops to
the red zone.
CAUTION: Do not operate machine when
battery meter needle is in the red zone, battery
damage will result.
7. If pad motor circuit breaker trips, reduce pad
pressure and/or replace soiled pad.
8. To stop burnishing release control grips. The
pad will automatically raise to the transport
position.
FOR SAFETY: When machine is left
unattended, stop on level surface, remove key
and set parking brake if equipped.
EMERGENCY STOPPING
To stop machine during an emergency, hit the red
power kill button located at rear of control
console. The power kill button immediately stops
all power to machine.
To reset power kill button, shut off all switches and
turn kill button to the right. Resume to normal
operation.
Power Kill Button
