MAINTENANCE
810D MM310 (3--95)
80
REAR SKIRTS
The two rear skirts are located on the bottom rear
of the main brush compartment. The vertical skirt
should clear the floor up to 20 mm (0.75 in) in
dusty conditions, and touch the floor otherwise.
The recirculation skirt is self-adjusting.
Check the skirts for wear or damage and
adjustment daily.
NOTE: Tire pressure will affect skirt clearances.
BRUSH DOOR SEALS
The brush door seals are located on both main
brush doors and on corresponding portions of the
main frame.
Check the seals for wear or damage every
100 hours of operation.
HOPPER SEALS
The hopper seals are located on the top and side
portions of the machine frame that contact the
hopper.
Check the seals for wear or damage every
100 hours of operation.
HOPPER DOOR SEALS
The hopper door seals are located on the hopper
door. They seal the hopper when the hopper door
is closed.
Check the seals for wear or damage every
100 hours of operation.
08494
08495
08496
08497
