T12 Service Information 9009917 (12-12)
3-15
MAINTENANCE
SCRUB BRUSHES
The machine can be equipped with either
disk
or
cylindrical
scrub brushes. Check scrub brushes
daily for wire or string tangled around the brush or
brush drive hub. Also check brushes or pads for
damage and wear.
DISK BRUSHES AND PADS
Replace the brushes or pads when they no longer
clean effectively.
Cleaning pads must be placed on pad drivers
before they are ready to use. The cleaning pad is
held in place with a center disk. Both sides of the
pad can be used for scrubbing. Turn the pad over
to use the other side.
Cleaning pads need to be cleaned immediately
after use with soap and water. Do not wash the
pads with a pressure washer. Hang pads, or lay
pads flat to dry.
NOTE: Always replace brushes and pads in sets.
Otherwise one brush or pad will be more
aggressive than the other.
REPLACING DISK BRUSHES OR PAD
DRIVERS
1. Raise the scrub head.
2. Turn off the machine.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
3. Open the main brush access door and side
squeegee support door.
4. Turn the brush until the spring handles are
visible.
5. Squeeze the spring handles and let the brush
drop to the floor.
6. Push the new brush under the scrub head,
align the brush drive socket with the brush
drive hub, and lift the brush up onto the brush
drive hub.
7. Ensure the brush is securely mounted on the
brush drive hub.
8. Close and secure the squeegee support door
and close the main brush access door.
9. Repeat procedure for the other brush.
Summary of Contents for EC-H2O T12
