EN
Removing the the brush/pad drivers
! ATTENTION: before carrying out the operations
GHVFULEHGEHORZVWRSRQDÀDWDQGOHYHOVXUIDFH
VZLWFKRႇWKHPDFKLQHDQGUHPRYHWKHLJQLWLRQNH\
! NOTICE
Where the terms RIGHT and LEFT appear, this is
always referred to the forward movement of the
machine
Releasing the right hand brush (or abrasive disk):
-
5HPRYHWKHULJKWKDQGVLGHÀDS
-
Turn the brush “anticlockwise” to unlock it from the
drive board.
-
5HSRVLWLRQWKHULJKWKDQGVLGHÀDS
Releasing the left hand brush (or abrasive disk):
-
Follow the same procedure as used to remove the
right brush, in this instance releasing it from the
drive board by turning in the “clockwise” direction.
Moving the machine when not in operation
To move the machine, proceed as follows:
-
Turn the ignition key to switch the machine on.
-
Depress the drive pedal: for forward motion, press
down on the front half of the pedal; for reverse
motion, on the rear half.
-
The top speed of the machine is adjusted by
turning the potentiometer.
To bring the machine to a halt, release the pedal.
When the machine comes to a stop, the parking brake is
applied.
7XUQWKHLJQLWLRQNH\WRVZLWFKRႇWKHPDFKLQH
25