OPERATION EN
7
OS3 DM20036 (3
−
2018)
HOW THE MACHINE WORKS
The Orbio os3 is an on
−
site generator that
produces cleaning and antimicrobial solutions for
institutional and commercial use. The os3 uses
electrolysis to convert water and salt into low
concentrations of sodium hydroxide (NaOH) for
cleaning and hypochlorous acid (HOCL) for
antimicrobial applications. These solutions are
diluted through the os3 dispenser as ready to use
products. No additional dilution is required.
NOTE: Store MultiSurface Cleaner and MultiMicro
200 Solution in a room/location where the
temperature is between 50
−
110
°
F (10
−
43
°
C).
WHILE OPERATING THE MACHINE
Periodically check the display panel indicators to
ensure there are no service alerts that need to be
cleared. Conditions must be cleared before the
os3 can be used again. Avoid running the system
completely out of salt. Add water softener salt to
the reservoir on a routine basis as the salt supply
is consumed. When the
add salt
indicator is
displayed the machine will stop until salt is added.
Refer to the
Filling the Salt Reservoir
section of
this manual.
NOTE: If water supply is turned off, unplug
machine until water supply is restored, then plug
machine in.
The operator is responsible for ensuring that the
solutions are at the proper pH and concentration
levels. Refer to
TESTING THE ANITMICROBIAL
SOLUTION
and
TESTING THE CLEANING
SOLUTION
in the Maintenance section of this
manual for proper testing procedures.
CLEANING SOLUTION
(top positions indicated in blue)
Multi
CLEANER
Multi
200
Micro
MultiSurface
Cleaner
is the cleaning solution
produced by the os3. MultiSurface
Cleaner
will
clean most soiled or dirty surfaces (wool, nylon
and polyester carpeting, glass, stainless steel,
other metal, ceramic, laminate, painted surfaces,
and other non
−
porous surfaces), but is not
recommended for cleaning heavy petroleum
based oils and greases.
NOTE: Always check carpet manufacturer
specifications for color stability and shrinkage
properties before using a water
−
based solution on
carpeting.
Do not dilute MultiSurface cleaning solution with
water. Water will diminish the cleaning
effectiveness. MultiSurface cleaner is ready to
use after dispensing.
FOR SAFETY: Do not mix MultiSurface
cleaning solution with conventional cleaning
chemicals. Do not drink. Refer the SDS (Safety
Data Sheet) for additional safety information
and precautions.
MultiSurface cleaner will remain effective for 30
days or more when stored in a clean, sealed
container. Test the cleaning solution to verify the
pH level is at the correct level if the solution has
been stored for longer than 30 days. Refer to the
Testing the Cleaning Solution
in MAINTENANCE
for additional testing information.
