Tennant T380AMR Operator'S Manual Download

Page: 26 / 88

T380AMR 9020999 (08-2020)

OPERATION

WHILE OPERATING THE MACHINE (ROBOTIC
MODE/MANUAL MODE)

Pick up rugs, obstructions, and oversized debris
before scrubbing. Pick up wire, string, twine,
large pieces of wood, or any other debris that
could become wrapped around or tangled in the
brushes.

Drive as straight a path as possible. Avoid
bumping into posts or scraping the sides of the
machine. Overlap the scrub paths by several
centimeters (a few inches).

Avoid turning the steering wheel too sharply when
the machine is in motion. The machine is very
responsive to the movement of the steering wheel.
Avoid sudden turns, except in emergencies.

Adjust the machine speed, brush pressure, and
solution

ow as required when scrubbing. Use the

minimal brush pressure and solution

ow settings

as possible.

If poor scrubbing performance is observed,
stop scrubbing and refer to MACHINE
TROUBLESHOOTING.

Perform the Daily Maintenance Procedures after
scrubbing (see MACHINE MAINTENANCE).

Drive the machine slowly on inclines. Use
the brake pedal to control machine speed on
descending inclines. Scrub with the machine up
inclines rather than down inclines. Do not teach a
robotic route on an incline or decline.

FOR SAFETY: When using machine in manual
mode, go slowly on inclines and slippery
surfaces.

FOR SAFETY: When using machine, place
proper

oor cleaning signage in areas

where the machine is operating and people
are present, in accordance with standard

oor cleaning practices. Follow site safety

guidelines concerning wet

oors.

See Autonomous Navigation Software End User
License Agreement (EULA) for further uses and
restrictions.

Do not operate machine in areas where the
ambient temperature is above 40° C (104° F). Do
not operate scrubbing functions in areas where the
ambient temperature is below 2° C (38° F).

FOR SAFETY: When using machine in manual
mode, do not scrub on ramp inclines that
exceed 7% / 4° grade or transport (GVWR) on
ramp inclines that exceed 10.5% / 6° grade.

FOR SAFETY: While machine is operating in
robotic mode, only scrub

at, hard surfaces of

0% incline.

To protect the lower LIDAR sensor from being
damaged from passersby, shopping carts, etc...
always park the machine with the front end facing
a wall or barrier.

WHILE OPERATING THE MACHINE (ROBOTIC
MODE ONLY)

This machine should only be used to scrub

at,

hard surfaces of 0% incline when operating in
robotic mode.

The machine is not designed or intended for use
in environments requiring fail-safe performance
including, but not limited to, any application where
machine failure could lead to personal injury or
property damage.

Do not attempt to ride the machine when it is
operating in the robotic mode. The machine is
equipped with joy ride sensors. If there is an
attempt to sit on the seat or hold the steering
wheel when operating in the robotic mode, the
machine will stop and trigger an alert. The operator
is responsible for supervising and monitoring safe
operation of the machine.