52
T380AMR 9020999 (08-2020)
OPERATION
9. Remove the debris tray from the recovery tank
and empty/rinse the debris tray.
10. Reinstall the debris tray into the recovery tank.
11. Reconnect the vacuum hose to the squeegee
assembly and center the squeegee assembly
under the machine.
12. Close the recovery tank cover.
NOTE: To allow the interior of the tank to dry,
leave the recovery tank cover open if machine is
not going to be immediately used again after the
recovery tank is drained. Allowing the interior of
the recovery tank to dry prevents mold/mildew
from building up inside the tank.
13. Inspect the solution tank interior for cleaning
detergent build up and hard water build up.
Proceed to the following step to clean the
solution tank if there is evidence of either.
14. Disconnect the solution tank drain hose from
the machine and slowly lower the drain hose to
the
fl
oor drain.
15. Remove the cap from the solution tank.
16. Flush the inside of the solution tank with clean
water.
17. Reconnect the solution tank drain hose to the
solution tank.
18. Remove and inspect the solution tank in-line
fi
lter after every 50 hours of operation. Clean
as necessary. Replace if damaged.
19. Reinstall the solution tank in-line
fi
lter onto the
machine.
20. Reinstall the cap onto the solution tank.
NOTE: To allow the interior of the tank to dry, do
not reinstall the solution tank cap if machine is
not going to be immediately used again after the
solution tank is drained. Allowing the interior of the
solution tank to dry prevents mold/mildew from
building up inside the tank.