75
T380AMR 9020999 (08-2020)
MAINTENANCE
5. Reset timer for new cartridge.
Carefully read and understand all steps
fi
rst
before performing procedure.
a. Turn
the
ON/OFF key switch
on.
b. Press and hold the service switch, located
on the
ec-H2O
module, for 10 seconds.
After releasing service switch, the three
solution
fl
ow indicator lights will begin to
(ripple) move back and forth.
c. Within 5 seconds after releasing the
service switch, while the three indicator
lights are moving back and forth, quickly
press and release the solution
fl
ow button
located on
ec-H2O
module.
The three indicator lights will then blink
three times to indicate timer has been
reset. Repeat process if the three indicator
lights do not blink three times.
Service switch
3 indicator lights
Solution flow button
7. Lower the recovery tank.
LUBRICATION
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
STEERING GEAR CHAIN
The steering gear chain is located directly above
the front tire. Check for damage or wear and
lubricate the steering gear chain after every 200
hours.
STEERING U-JOINT
The steering u-joint is located directly below the
steering motor. Check for damage or wear and
lubricate the steering u-joint after every 200 hours.