PLDC04453
REVISION 00
December 23, 2020
TECHNICAL OFFICE
Stavale
13
Remove the plastic joint
N
splined onto the shaft of the reduction unit-differential.
14
Check tightness of the oil seal
I
, the shaft must be dry, without any traces of oil, otherwise replace
the seal.
15
If replacing the oil seal
I
, use a new one of the same type and size.
SC 12 22 5
Type:
SC
(without dust lip)
Size:
12
mm / 0,47 in (inside diameter) x
22
mm / 0,87 in (outside diameter) x
5
mm / 0,20 in (height).
16
Remove the oil seal
I
from its seat, using a sharp tool to perforate it, and a hook to pull it out, otherwise
remove the reduction unit-differential
E
.
17
Before fitting the new oil seal, cover the sharp edges of the shaft, to avoid cutting the lip on the oil seal.
18
Fit the new oil seal
I
fully onto the reduction unit-differential
E
, for convenience use a special ring
installer, or a wrench socket, max OD 22 mm / 0,87 in.
Fig. 110
I
D max Ø 22 mm / 0,87 in
I
N
N
Fig. 108
I
Fig. 109
Oil
I
I
51 of 73