T5e ec--H2O Kit
KIT NO. 9006828
Page 1 of 9
t
9006829 Rev. 00 (12--09)
Tennant Company
Customer Service: (800) 553--8033 or (763) 513--2850
This kit includes the parts needed to convert a standard model over to an ec--H2O
t
model.
INSTALLATION INSTRUCTIONS:
Installation Time: 4--6 Hours
Special Tools Required: None
PREPARE MACHINE FOR KIT INSTALL:
1. Drain the solution and recovery tanks.
2. Park the machine on a level surface, lower the
scrub head and remove the key.
3. Remove the scrub head assembly from the
machine (Figure 1).
FOR SAFETY: Before removing the scrub head
assembly, disconnect the battery cables.
Disk Model
shown
Fig. 1
4. Remove the batteries from the machine
(Figure 2).
FOR SAFETY: When handling batteries, wear pro-
tective gloves and eye protection. Avoid contact
with battery acid.
Fig. 2
INSTALL
ec- H2O
WIRE HARNESS:
1. Remove the cover the from the circuit breaker box
and install
ec--H2O
wire harness [p/n 1055447]
(Figure 3).
Circuit
Breaker
Cover
Fig. 3
2. Starting from inside the circuit breaker box,
connect the following
ec--H2O
harness wires as
described in steps 3, 4 and 5 (Figure 4).
Relay
[p/n 1012216]
Red 1z
Black 13u/13T/13z/13s
Fig. 4
3. Connect red wire (1z) to the brush contactor
terminal and the black wires (13u/13T/13z/13s) to
the ground stud (Figure 5).
Red 1z
Black 13u/13T/13z/13s
Fig. 5
Home
Find...
Go To..
