OPERATION
Tennant T600 EE (04-2018)
13
INSTALLING AND REMOVING DISK
BRUSHES/PADS
(Disk Scrub Head Model)
1. Raise scrub head off floor and remove key.
FOR SAFETY: Before leaving or servicing machine,
stop on level surface, turn off machine and remove
key.
2. Attach the pad to the pad driver before installing
the driver. Secure pad with center-lock (Figure 12).
FIG. 12
FOR SAFETY: Do not operate machine with pads
or accessories not supplied or approved by
Tennant. The use of other pads may impair safety.
3. Set the yellow spring clips to the open position to
make brush installation easier. Press spring clips
together then downward to set (Figure 13).
FIG. 13
4. Align the pad driver or brush under the motor hub
and push it upward to engage hub (Figure 14).
Replace pads or brushes when they no longer
clean effectively or when the bristles on the brush
disk are worn to the yellow indicator (Figure 14).
FIG. 14
5. To remove the pad drivers/brushes, raise the scrub
head and press down on the yellow pad release
plunger (Figure 15). Pad will drop to floor.
FIG. 15
