OPERATION
16
Tennant T600 EE (04-2018)
CONTROL PANEL OPERATION
The control panel operation can be set up with lockout
functionality by using the Supervisor Controls feature.
This will prevent the operator from changing or saving
the settings. See
SUPERVISOR CONTROLS
instructions at the back of the manual.
The supervisor controls feature will lower machine
variability for consistent, repeatable cleaning results,
provide machine quality assurance regardless of user
experience, and reduce user training requirements.
1-STEP BUTTON
With key turned on, press the 1-STEP button to
activate the scrub function (Figure 24). The scrub head
will lower to floor. Press button again to stop the scrub
function and to raise scrub head.
FIG. 24
BRUSH PRESSURE BUTTON
Press the brush pressure button to increase or
decrease the brush pressure (Figure 25). The brush
pressure LED indicator will display the pressure setting.
One LED = Low pressure,
two LEDs = Medium pressure, three LEDs = High
pressure.
Low
High
Med
FIG. 25
NOTE: If brush pressure is set too high for scrubbing
conditions, the brush pressure setting will automatically
reduce to a lower setting and begin flashing. The
flashing LED alerts the operator to reduce the brush
pressure setting to prevent brush motor overload.
SOLUTION FLOW BUTTON
Press the solution flow button to increase or decrease
the solution flow rate (Figure 26). The solution flow
indicator will display flow setting.
No LED = No flow, One LED = Low flow, two LEDs =
Medium flow, three LEDs = High flow.
FIG. 26
QUIET-MODE BUTTON
Press the Quiet-Mode button to reduce the vacuum
motor sound . A green LED in the corner will turn on
when activated. Press button to turn off.
FIG. 27