OPERATION
Tennant T600 EE (04-2018)
19
5. To begin scrubbing, start out slowly by gradually
pulling back on the variable speed control start bail
(Figure 35). Slightly let up on the start bail to slow
the machine down around corners, near crossings
and when approaching tight areas, etc.
FIG. 35
6. To adjust the scrubbing speed, turn the speed dial
to the desired speed (Figure 36).
FIG. 36
7. To stop scrubbing, release the start bail and press
the 1-STEP button. Continue to drive machine
forward to pick up any remaining water then raise
squeegee assembly off floor. Turn key off.
FOR SAFETY: Before leaving machine, stop on
level surface, turn off machine and remove key.
DOUBLE SCRUBBING
Double scrubbing is the process of making two or more
passes over a heavily soiled area. The first pass is
made with the squeegee raised off the floor (Figure
37). This allows the solution to penetrate the soiled
area for an extended period (3-5 minutes). The second
pass is made with the squeegee lowered.
FOR SAFETY: When operating machine, wear
closed-toe, non-slip shoes and go slowly on
inclines and slippery surfaces.
FOR SAFETY: When operating machine, follow site
safety guidelines concerning wet floors.
1st pass - squeegee up
2nd pass - squeegee down
FIG. 37
EMERGENCY SHUT-OFF BUTTON
Push the emergency shut-off button in the event of an
emergency (Figure 38). This red button shuts off all
power to machine. To regain power, turn the button
clockwise and restart the key.
FIG. 38
