50
T600/T600e 9016605 (04-2018)
MAINTENANCE
PUSHING AND TRANSPORTING
MACHINE
PUSHING MACHINE
If the machine becomes disabled, it can be pushed
as describe below.
Only push the machine for a very short distance and
do not exceed 3.2 kp/h (2 mph). It is not intended to
be pushed for a long distance or at a high speed.
For models equipped with an electronic parking
brake system, the brake must be disengaged before
pushing machine. To disengage brake, position the
brake lever on the transaxle to the down position.
ATTENTION: Do not push machine for a long
distance or damage may occur to the propelling
system.
Immediately after pushing the machine, re- engage
the brake lever to prevent a roll hazard.
NOTE: When brake lever is disengaged, the propel
will be disabled and a fault will be detected until lever
is re-engaged.
FOR SAFETY: When servicing machine, do
not push the machine on inclines with brake
disabled.
TRANSPORTING MACHINE
When transporting the machine by use of trailer
or truck, carefully follow loading and tie-down
procedure.
1. Drain tanks, raise scrub head and remove scrub
disks and squeegee assembly.
2. Carefully load machine in trailer or on truck.
FOR SAFETY: When loading/unloading, use a
ramp that can support the machine weight and
operator.
FOR SAFETY: When loading/unloading, the
machine may only be operated on gradients up
to 2%.
3. Once loaded, position the front of the machine up
against the front of the trailer or truck. Lower the
scrub head and turn key off
4. Place a block behind each wheel.
5. Using tie-down straps, secure the machine
using the four tie-down brackets located on the
machine frame. It may be necessary to install tie-
down brackets to the fl oor of your trailer or truck.
NOTE: When transporting machine in an open truck
or trailer, secure recovery tank lid.
ATTENTION: Do not use control console area or
accessory rails for tie-down locations, damage
may occur.
Optional Transport Kit
Part No. 9042166
Recovery Tank Lid Latch
Summary of Contents for T600e
