15
T7AMR 9018134 (12-2021)
OPERATION
OPERATION OF CONTROLS
DIRECTIONAL SWITCH
Press the top of the
directional switch
to move the
machine forward. The forward arrow light located
at the top of the switch will illuminate when the
machine is placed in the forward direction.
Press the bottom of the
directional switch
to move
the machine in reverse. The reverse arrow light
located at the bottom of the switch will illuminate
when machine placed in the reverse direction.
SETTING SCRUB MODES
Before scrubbing, select the type of scrubbing
to be used,
ec-H2O
(option) or conventional
scrubbing. Then set the preferred brush pressure,
and solution flow settings.
NOTE: The machine does not save solution flow
and brush pressure settings for a robotic route, as
cleaning needs may change. Adjust the solution
flow and brush pressure settings before pressing
the blue start/pause button to begin a robotic
route.
SETTING
ec-H2O
BUTTON
The
ec-H2O
button
enables the
ec-H2O
system to
come on when the
1-Step button
is on. The light in
the button will come on when it is in this mode.
NOTE: The ec-H2O system indicator light will not
turn on until the machine starts scrubbing.
NOTE: ec-H2O Models-During first time use and
after replacing the water conditioning cartridge,
the ec-H2O system will automatically override the
selected solution flow rate for up to 75 minutes.
