16
T7AMR 9018134 (12-2021)
OPERATION
SETTING BRUSH PRESSURE
Under normal conditions, the brush pressure
should be set to the minimum setting (the bottom
light). Under heavy grime conditions, the brush
pressure should be set to the maximum setting
(the middle or top lights). Travel speed and floor
conditions will affect scrubbing performance.
With the
1-Step button
activated, press the
Brush
pressure button
to both increase or increase the
brush pressure settings. The brush pressure
indicator lights display the current brush pressure
setting.
SETTING SOLUTION FLOW
Under normal soilage conditions the solution
flow level should be set to the lowest setting (the
bottom light). Under heavy grime conditions, the
solution flow level should be set to a higher setting
(middle or top lights). Travel speed and floor
conditions will affect scrubbing performance.
With the
1-Step button
activated, press the
Solution flow button
to both increase or decrease
the solution flow. The solution flow indicator lights
display the current solution flow setting.
NOTE: It is recommended that medium or high
solution flow levels be used for uncoated or
unpolished floors (more porous). This applies to
both conventional and ec-H2O scrubbing modes.
NOTE: The machine will operate for a longer time
if the Brush Pressure and Solution Flow settings
are set to lowest setting (bottom lights).
ec-H2O
SOLUTION FLOW SETTING
To adjust the solution flow rate when
ec-H2O
scrubbing, press the
solution flow button
located
on the
ec-H2O
module. One LED= low, two
LED’s=medium, and three LED’s= high. The
ec-H2O
module is located under the seat.
