14. When the caution light
is lit all the time, even though
the gate has stopped.
15. LED lighting
does not work.
16. The door opens
automatically before it
is completely closed.
17. The gate stops
while opening.
18. Remote control does
not work or has a small
operating range.
19. A new remote control
can not be added.
20. The display shows
the „F” symbol.
21. The symbol „ . ” appears on
the display.
22. The drive works, but
the gate does not move.
24. Other unusual problems.
23. The battery does
not power the drive.
Power board damaged.
a) The lighting cable
is not connected.
b) LED diodes damaged.
c) Power board damaged.
a) The automatic reversing
function after detecting
an obstacle is activated.
b) The gate is incorrectly installed.
c) The gate is blocked during
closing.
a) The overload function
is activated.
b) The gate is incorrectly installed.
c) The gate is blocked
during opening.
a) Low battery.
b) The antenna is not connected
or placed inside the drive.
c) Radio signal interference.
The new remote control is not
compatible with the drive.
The drive’s memory is full.
The drive reached max. number
of programmed remotes control.
The pass door is open.
Motor shaft damaged.
External devices are not
compatible with the drive.
a) Discharged battery.
b) The battery is incorrectly
connected.
c) Damaged wires connecting
the battery with the drive.
a) Charge the battery.
b) Check the correctness of connection.
c) Replace the wires connecting
the battery with the drive.
Replace the power board.
a) Check the LED connection.
b) Replace the LEDs.
c) Replace the power board.
a) Check the place of blocking the
gate and set the limit positions again.
b) Increase the power of the
drive overload.
a) Check the place of blocking the gate
and set the limit positions again.
b) Increase the power
of the drive overload.
a) Replace the battery.
b) Place the antenna outside the drive.
c) Remove radio signal interference.
Select remote control
compatible with the drive.
Remove programmed remote controls.
Check the security connections
in pass door.
Replace the motor shaft.
Disconnect all external devices.
If you still have unusual problems,
replace the control board.
